Heavy Duty Road Stud Lights For Highways C2--RUICHEN Road Stud Light Suppiler

Heavy Duty Road Stud Lights Features:

High brightness America brand led light with 100000 hours of working time.
USA brand solar panel. 22% high conversion rate. Fast charge rate.
Japan brand casting Al material. Road Stud Lights bear more pressure.
Most quality Epoxy resin glue to fix the Road Stud Lights, making sure of solar power charge.
Philips PC board, safe and stable. Long-time warranty for solar studs reflectors.
The leader of Road Stud Lights. Load capacity:>40T(can be installed in the middle of the road)

Heavy Duty Road Stud Lights For Highways C2

Aluminum Road Stud Lights Parameters:

Material:	Aluminium(GB-ADC-12)+PC(Japan Brand)
Power supply:	USA Brand High Efficient Solar Panel 5V/60MA for lithium battery 3V/120MA for super capacitor
Battery:	Lithium battery 3.2V/500MA(made in Japan); Supercapacitor 2.3V/120F(made in Korea)
Working model:	Blinking or Constant Charging in the daytime and working automatically at night
Life span:	5years for lithium battery; 10years for supercapacitor.
Resistance:	> 40T(can be installed in the middle of road)
Size:	φ12550mm (φ4.92″1.97″)
Visual distance:	>800M
Water poof:	IP68
Carton Size:	1pcs/box; 30pcs/ctn; weight: 30kgs; carton size: 67.52820cm 1pcs/box; 30pcs/ctn; weight: 66.14bs; carton size: 26.57″11.02″7.87″

Application of Heavy Duty Road Stud Lights C2:

♥Schools and hospitals

♥Highways

♥High traffic areas

♥Walking paths

♥Transit stations

♥Parks and campuses

♥Road Center

How to install Aluminum Road Stud Lights C2:

1.Carefully mark the distance between the placement of Road Stud Lights. To prevent an adverse effect on the ground, use a proper tool such as Core Drill. Drill 127mm and depth will be 45mm.

2.Remove all debris from the installation hole.

3.Pour epoxy into the holes per the manufacturer’s instruction.

4.Verity that the installation hole is straight. Verify that the installation hole is large enough to allow the epoxy to surround the Road Stud Lights shaft.

5.Set the lighting surface of the Road Stud Lights to the desired viewing angle. Verify the epoxy is evenly adhering to the installation hole and Road Stud Lights shaft.

After curing the LED Road Stud Lights for 6-8 hours, remove the installation of the isolation facility.